Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH (for Fold Down Seat Type)

SEAT HEATER SWITCH (for Fold Down Seat Type) > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH (for LH)


  1. Check the seat heater switch (for LH).



      B373394E02
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for LH))

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 7
      Off
      10 kΩ or higher
      1 - 7
      On
      Below 50Ω
      1 - 8
      Always
      2.4 kΩ

      If the result is not as specified, replace the seat heater switch (for LH).



  1. Check the switch illumination and indicator.



      B373394E02
    1. Apply battery voltage to the seat heater switch (for LH) and check that the switch illumination and indicator come on.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for LH))

      Standard:
      Measurement Condition
      Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 8
      Always
      Indicator comes on
      Battery positive (+) → Terminal 3
      Battery negative (-) → Terminal 5
      Always
      Switch illumination comes on

      If the result is not as specified, replace the seat heater switch (for LH).



2. INSPECT SEAT HEATER SWITCH (for RH)


  1. Check the seat heater switch (for RH).



      B373394E02
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for RH))

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 7
      Off
      10 kΩ or higher
      1 - 7
      On
      Below 50Ω
      1 - 8
      Always
      2.4 kΩ

      If the result is not as specified, replace the seat heater switch (for RH).



  1. Check the switch illumination and indicator.



      B373394E01
    1. Apply battery voltage to the seat heater switch (for RH) and check that the switch illumination and indicator come on.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for RH))

      Standard:
      Measurement Condition
      Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 8
      Always
      Indicator comes on
      Battery positive (+) → Terminal 3
      Battery negative (-) → Terminal 5
      Always
      Switch illumination comes on

      If the result is not as specified, replace the seat heater switch (for RH).