DTC P0500 Vehicle Speed Sensor "A" |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0500 | While vehicle being driven, no vehicle speed sensor signal transmitted to ECM (1 trip detection logic). |
|
| Required Sensors/Components (Main) | Vehicle speed sensor Combination meter assembly Skid control ECU |
| Required Sensors/Components (Related) | Park/Neutral position switch assembly Engine coolant temperature sensor Crankshaft position sensor Throttle position sensor Mass air flow meter sub-assembly |
| Frequency of Operation | Continuous |
| Transmission counter gear revolution | 300 rpm or higher |
| Vehicle speed sensor signal | No signal |

| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING GTS (VEHICLE SPEED) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the GTS.
| Result | Proceed to |
| Values displayed on GTS and speedometer display not equal | A |
| Values displayed on GTS and speedometer display equal | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
Disconnect the combination meter assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I18-3 (+S) - A25-57 (SPD) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER SYSTEM |
Check the circuits that send vehicle speed signals to this system in the combination meter system (Click here).
| NEXT | |
| 4.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs (Click here).
Turn the ignition switch off and wait for at least 30 seconds.
Start the engine.
Turn the GTS on.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine and ECT / Trouble codes.
| NEXT | ||
| ||