Home › Vehicle Exterior › WINDOW / GLASS › FRONT PASSENGER SIDE POWER WINDOW SWITCH (for TMMK Made)

FRONT PASSENGER SIDE POWER WINDOW SWITCH (for TMMK Made) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


  1. Check the switch function.



      B351354E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      5 - 7
      Auto up or manual up position
      Below 1 Ω
      4 - 7
      Auto down or manual down position
      Below 1 Ω
      7 - 8
      Auto up or auto down position
      Below 1 Ω
      4 - 5
      Off
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly)
      If the result is not as specified, replace the power window regulator switch assembly.



    B351354E01
  1. Check that the LED illuminates.

    1. Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

      OK:
      Battery Connection
      Specified Condition
      Battery positive (+) → 3
      Battery negative (-) → 1
      LED illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly)
      If the result is not as specified, replace the power window regulator switch assembly.