Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH (for TMMK Made)

REAR POWER WINDOW SWITCH (for TMMK Made) > INSPECTION

for Preparation Click here



1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH


    B351355E01
  1. Check the switch function.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 - 7
      Up
      Below 1 Ω
      1 - 4
      Up
      Below 1 Ω
      3 - 7
      Off
      Below 1 Ω
      1 - 4
      Off
      Below 1 Ω
      3 - 7
      Down
      Below 1 Ω
      1 - 2
      Down
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly (for Rear LH Door))
      If the result is not as specified, replace the rear power window regulator switch assembly (for rear LH door).



    B351355E01
  1. Check that the LED illuminates.

    1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

      OK:
      Battery Connection
      Specified Condition
      Battery positive (+) → 6
      Battery negative (-) → 5
      LED illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly (for Rear LH Door))
      If the result is not as specified, replace the rear power window regulator switch assembly (for rear LH door).



2. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH


    B351355E01
  1. Check the switch function.

    1. Measure the resistance when the switch is operated according to the value(s) in the table below.
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 - 7
      Up
      Below 1 Ω
      1 - 4
      Up
      Below 1 Ω
      3 - 7
      Off
      Below 1 Ω
      1 - 4
      Off
      Below 1 Ω
      3 - 7
      Down
      Below 1 Ω
      1 - 2
      Down
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly (for Rear RH Door))
      If the result is not as specified, replace the rear power window regulator switch assembly (for rear RH door).



    B351355E01
  1. Check that the LED illuminates.

    1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

      OK:
      Battery Connection
      Specified Condition
      Battery positive (+) → 6
      Battery negative (-) → 5
      LED illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly (for Rear RH Door))
      If the result is not as specified, replace the rear power window regulator switch assembly (for rear RH door).