Home › Vehicle Exterior › WINDOW / GLASS › REAR DOOR POWER WINDOW REGULATOR MOTOR (for TMMK Made)

REAR DOOR POWER WINDOW REGULATOR MOTOR (for TMMK Made) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    B127536E07
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    OK:
    Battery Connection
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise

    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Motor Assembly LH)
    *b
    Motor Gear
    *c
    Clockwise
    *d
    Counterclockwise
    If the result is not as specified, replace the power window regulator motor assembly LH.



2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    B127535E03
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    OK:
    Battery Connection
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates counterclockwise

    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Motor Assembly RH)
    *b
    Motor Gear
    *c
    Counterclockwise
    *d
    Clockwise
    If the result is not as specified, replace the power window regulator motor assembly RH.