Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COMBINATION METER ASSEMBLY
  1. INSPECT SPEEDOMETER

    NOTICE:
    1. The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake actuator assembly (skid control ECU) because it is the source of the vehicle speed signal.
    2. Data List values of the brake actuator assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.
    3. If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


    1. Before starting the following inspection, check if the vehicle stability control system outputs the DTCs.

    2. Read the Data List according to the display on the GTS.

      ABS/VSC/TRC 
      Tester Display
      Measurement Item/Range
      Normal Condition
      Diagnostic Note
      Vehicle Speed
      Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
      Vehicle stopped: 0 km/h (0 mph)
      -

      Standard: km/h 
      GTS Indication (km/h)
      Acceptable Range (km/h)
      20
      21.0 to 25.0
      40
      41.7 to 46.2
      60
      62.7 to 67.2
      80
      83.4 to 88.4
      100
      104.3 to 109.3
      120
      125.1 to 130.6
      140
      145.8 to 151.8
      160
      166.2 to 173.2
      180
      186.9 to 194.5
      200
      207.7 to 215.7

  1. INSPECT TACHOMETER

    1. Connect the GTS, and start the engine.

    2. Compare the test results with the tachometer indications.

      Standard 
      GTS Indication (rpm)
      Acceptable Range
      Data in ( ) is for Reference
      700
      630 to 770
      1000
      (900 to 1100)
      2000
      (1850 to 2150)
      3000
      2800 to 3200
      4000
      (3800 to 4200)
      5000
      4800 to 5200
      6000
      (5750 to 6250)
      7000
      6700 to 7300

  1. CHECK LED ILLUMINATION

    1. Check the illumination function of the warning or indicator lights listed below when turning the ignition switch to ON.

      OK:

      Warning or Indicator Light
      Specified Condition
      Master warning light
      Warning or indicator light comes on for about 3 seconds after turning the ignition switch to ON.
      Eco driving indicator light
      Brake warning light
      Slip indicator light
      ABS warning light
      VSC OFF indicator light
      AFS OFF indicator light*1
      Speed warning light*2
      SRS warning light
      Warning light comes on for about 6 seconds after turning the ignition switch to ON.
      EPS warning light
      Warning light comes on when turning the ignition switch to ON.
      MIL (Check engine warning light)

      1. *1: w/ AFS (Adaptive Front-lighting System)
      2. *2: w/ Speed Warning