DTC P0798 Pressure Control Solenoid "C" Electrical (Shift Solenoid Valve SL3) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0798 | The TCM checks for an open or short in the shift solenoid valve SL3 circuit while driving and shifting gears. (1-trip detection logic)
|
|

| 1.INSPECT TRANSMISSION WIRE (SL3) |
![]() |
Remove the TCM from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 16 (SL3+) - 15 (SL3-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 16 (SL3+) - Body ground and other terminals | Always | 10 kΩ or higher |
| 15 (SL3-) - Body ground and other terminals | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | ||
| ||
| 2.INSPECT SHIFT SOLENOID VALVE SL3 |
![]() |
Remove shift solenoid valve SL3.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
| *1 | Shift Solenoid Valve SL3 |
Connect a battery positive (+) lead with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating sound.
|
| ||||
| OK | ||
| ||