POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > OPERATION CHECK |
| CHECK WINDOW LOCK SWITCH |
![]() |
When the window lock switch of the power window regulator master switch assembly is pushed, check that the front passenger and rear windows are disabled.
When the window lock switch is pushed again, check that the front passenger and rear windows can be operated normally.
| CHECK MANUAL UP / DOWN FUNCTION |
Check that the driver door power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Engine switch on (IG) | Driver door | Pulled halfway up | Up (Closes) |
| Pushed halfway down | Down (Opens) |
Check that the front passenger door window and rear power windows operate as follows:
| Condition | Regulator Switch | Switch Operation | Power Window |
| Front passenger door | Pulled halfway up | Up (Closes) |
| Pushed halfway down | Down (Opens) | ||
| Rear LH door | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) | ||
| Rear RH door | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) |
| CHECK AUTO UP / DOWN FUNCTION |
Check that the driver door power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Engine switch on (IG) | Driver door | Pulled up (One touch operation) | Auto up (Closes) |
| Pushed down (One touch operation) | Auto down (Opens) |
Check that the front passenger door window operate as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Front passenger door | Pulled up (One touch operation) | Auto up (Closes) |
| Pushed down (One touch operation) | Auto down (Opens) |
| CHECK REMOTE MANUAL UP / DOWN FUNCTION |
Check that the front passenger door window and rear power windows operate as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Front passenger door | Pulled halfway up | Up (Closes) |
| Pushed halfway down | Down (Opens) | ||
| Rear LH door | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) | ||
| Rear RH door | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) |
| CHECK REMOTE AUTO UP / DOWN FUNCTION |
Check that the front passenger door window operate as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Front passenger door | Pulled up (One touch operation) | Auto up (Closes) |
| Pushed down (One touch operation) | Auto down (Opens) |
| CHECK KEY-OFF OPERATION FUNCTION |
Check that each power window can be operated with the power window regulator master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly after the engine switch is turned off.
Check that the key-off operation function does not operate after the driver door or front passenger door is opened.
Check that all the power windows cannot be operated after more than approximately 43 seconds have elapsed since the engine switch was turned off.
| CHECK JAM PROTECTION FUNCTION |
Check the basic function (for driver door and front passenger door).
Fully open the window.
![]() |
Set a check jig wrapped with a piece of cloth near the window fully closed position.
| *a | Check Jig |
| *b | Cloth |
Operate the auto up or manual up function to check that the power window stops and goes down after the check jig is caught between the window and door frame, and stops when the opening reaches approximately 200 mm (7.87 in.) or approximately 5 seconds have elapsed.
While the power window is moving down, check that the door glass cannot be raised using the power window switch.
| CHECK CATCH PROTECTION FUNCTION |
![]() |
Check the basic function (for driver door and front passenger door).
Fully close the window.
Operate the auto down or manual down function to open the window, grasp the upper edge of the door glass with one or two hands and check that the power window stops.
| CHECK POWER WINDOW SWITCH LED ILLUMINATION |
Check the LED illumination (power window regulator master switch assembly).
Check that the LEDs located in the power window regulator master switch assembly illuminate when the light control switch is in the tail position.

Check the LED illumination (power window regulator switch assembly).
Check that the LED located in the power window regulator switch assembly illuminates when the light control switch is in the tail position.

Check the LED illumination (rear power window regulator switch assembly).
Check that the LED located in each rear power window regulator switch assembly illuminates when the light control switch is in the tail position.
