HORN > INSPECTION |
| 1. INSPECT HIGH PITCHED HORN ASSEMBLY (for TMC, TMMR Made) |
![]() |
Apply battery voltage and check the operation of the horn according to the table below.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal A4-1 Battery negative (-) → Body ground | Horn sounds |
| *a | Component without harness connected (High Pitched Horn Assembly) |
| *b | Body ground |
| 2. INSPECT LOW PITCHED HORN ASSEMBLY (for TMC, TMMR Made) |
![]() |
Apply battery voltage and check the operation of the horn according to the table below.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal A1-1 Battery negative (-) → Body ground | Horn sounds |
| *a | Component without harness connected (Low Pitched Horn Assembly) |
| *b | Body ground |
| 3. INSPECT HIGH PITCHED HORN ASSEMBLY (for TMMK Made) |
![]() |
Apply battery voltage and check the operation of the horn according to the table below.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal A4-1 Battery negative (-) → Body ground | Horn sounds |
| *a | Component without harness connected (High Pitched Horn Assembly) |
| *b | Body ground |
| 4. INSPECT LOW PITCHED HORN ASSEMBLY (for TMMK Made) |
![]() |
Apply battery voltage and check the operation of the horn according to the table below.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal A1-1 Battery negative (-) → Body ground | Horn sounds |
| *a | Component without harness connected (Low Pitched Horn Assembly) |
| *b | Body ground |