Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2GR-FE)

COMPRESSOR (for 2GR-FE) > REASSEMBLY

for Preparation Click here



1. INSTALL MAGNET CLUTCH ASSEMBLY


    E231355
  1. Install the magnet clutch stator with the parts aligned as shown in the illustration.



    I032461
  1. Using a snap ring expander, install a new snap ring with the chamfered side facing outward.

  1. Engage the clamp.



    I031582
  1. Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.

    NOTICE:
    Do not damage the seal cover of the bearing when installing the snap ring.

  1. Install the magnet clutch washer(s) and magnet clutch hub.

    NOTICE:
    Use the same magnet clutch washer(s) as removed during disassembly.



    E156530E01
  1. Using SST, hold the magnet clutch hub and install the bolt.

    SST
    07112-76060  

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



2. INSTALL COOLER BRACKET


    E231354
  1. Install the cooler bracket with the screw.

  1. Engage the clamp.

  1. Connect the connector.



3. INSPECT MAGNET CLUTCH CLEARANCE


    E156531
  1. Clamp the cooler compressor in a vise between aluminum plates.

  1. Set a dial indicator to the magnet clutch hub.

  1. Connect a positive lead from the battery to terminal 3 of the magnet clutch connector and a negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

    Standard clearance:
    0.35 to 0.60 mm (0.0138 to 0.0236 in.)

    If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.

    Magnet clutch washer thickness:
    0.1 mm (0.00394 in.)
    0.3 mm (0.0118 in.)
    0.5 mm (0.0197 in.)

    NOTICE:
    Adjustment should be performed with 3 or fewer magnet clutch washers.

  1. Remove the compressor and magnetic clutch from the vise.