Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT LEVELING SWITCH


  1. Voltage Check



      E190203E03
    1. Connect a positive (+) lead from the battery to terminal 1 (B) and a negative (-) lead to terminal 4 (E).

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Condition
      Position
      Specified Condition
      (Battery voltage is 12 V)
      2 (T) - 4 (E)
      0
      10.44 to 11.16 V
      1
      8.52 to 9.24 V
      2
      6.6 to 7.32 V
      3
      4.68 to 5.4 V
      4
      2.76 to 3.48 V
      5
      0.84 to 1.56 V

      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)
      If the result is not as specified, replace the headlight leveling switch.



    E190203E02
  1. LED Illumination Inspection

    1. Apply battery voltage to the headlight leveling switch and check that the switch illuminates.

      OK:
      Tester Connection
      Specified Condition
      Battery positive (+) → Terminal 3 (ILL+)
      Battery negative (-) → Terminal 4 (E)
      Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)
      If the result is not as specified, replace the headlight leveling switch.