Home › Engine / Hybrid System ยท 2AR-FE › FUEL › FUEL PRESSURE REGULATOR (for TMC, TMMR Made)

FUEL PRESSURE REGULATOR (for TMC, TMMR Made) > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)


2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A136021
  1. Disconnect the fuel sender gauge connector.



    A136022
  1. Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.



3. REMOVE LOWER FUEL TANK CASE SUB-ASSEMBLY


    A136231
  1. Disconnect the fuel pump harness connectors from the fuel suction plate.



    A136234E03
  1. Using needle nose pliers, remove the E-ring.
    Text in Illustration 
    *1
    E-ring



    A211200E02
  1. Disengage the 4 claws of the No. 1 fuel suction support and remove the lower fuel tank case sub-assembly from the fuel suction plate with the fuel filter.
    Text in Illustration 
    *1
    Tube

  1. Remove the spring from the fuel suction plate.

    NOTICE:
    Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube (Click here).



4. REMOVE NO. 1 FUEL SUCTION SUPPORT


    A255954
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.



5. REMOVE FUEL PUMP


    A136239E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter

    NOTICE:
    1. Do not damage the fuel filter.
    2. Do not remove the suction filter.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A283925
  1. Disconnect the fuel pump harness connector.



    A292649E01
  1. Remove the O-ring and spacer from the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Spacer
    *a
    5.0 mm (0.197 in.)

    NOTICE:
    Be careful not to damage the sealing surface.

    HINT:
    If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A136235
  1. Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly from the fuel filter.

    NOTICE:
    Slowly pull out the fuel pressure regulator assembly because the O-ring is firmly installed between the fuel pressure regulator assembly and the fuel filter.



    A148186E11
  1. Remove the 2 O-rings from the pressure regulator assembly.
    Text in Illustration 
    *1
    O-ring