ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR |
Install a new gasket to the engine coolant temperature sensor.
Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor.
Connect the engine coolant temperature sensor connector.
Install the wire harness with the 2 bolts.
| 2. INSTALL INLET AIR CLEANER ASSEMBLY |
Install the inlet air cleaner with the 2 bolts.
| 3. INSTALL COOL AIR INTAKE DUCT SEAL (for TMC, TMMR Made) |
Install the cool air intake duct seal with the 9 clips.
| 4. INSTALL COOL AIR INTAKE DUCT SEAL (for TMMK Made) |
Install the cool air intake duct seal with the 9 clips.
| 5. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
![]() |
Slowly fill the radiator assembly with engine coolant.
| *a | Code Mark |
| Code Mark "M" | 6.9 liters (7.3 US qts, 6.1 Imp. qts) |
| Code Mark "G" | 7.0 liters (7.4 US qts, 6.2 Imp. qts) |
| Code Mark "Z" | 7.3 liters (7.7 US qts, 6.4 Imp. qts) |
Remove the reserve tank cap.
Slowly pour engine coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 radiator hose and No. 2 radiator hose several times by hand, and then check the level of the engine coolant.
If the engine coolant level is low, add engine coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the engine coolant for several minutes.
Maintain the engine speed at 2500 to 3000 rpm.
Squeeze the No. 1 radiator hose and No. 2 radiator hose several times by hand to bleed air from the cooling system.
Stop the engine, and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 6. INSPECT FOR COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.
| 7. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Fit the 3 retainers and install the No. 1 engine cover sub-assembly.
| 8. INSTALL ENGINE UNDER COVER RH |
| 9. INSTALL ENGINE UNDER COVER LH |
| 10. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH |
| 11. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH |