Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


2. REMOVE ENGINE UNDER COVER LH


3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


4. REMOVE ENGINE UNDER COVER RH


5. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

  1. Loosen the cylinder block drain cock plug (for Bank 1).

  1. Loosen the cylinder block drain cock plug (for Bank 2, w/ Cylinder Block Drain Cock Plug).



  1. Remove the radiator cap sub-assembly.


    A255284E02


    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Cylinder Block Drain Cock Plug (for Bank 1)
    *3
    Cylinder Block Drain Cock Plug (for Bank 2, w/ Cylinder Block Drain Cock Plug)
    *4
    Radiator Drain Cock Plug
    *5
    Air Drain Cock Plug
    -
    -

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.



6. REMOVE COOL AIR INTAKE DUCT SEAL


    B382622
  1. Remove the 9 clips and cool air intake duct seal.



7. REMOVE V-BANK COVER SUB-ASSEMBLY


    A255420
  1. Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.



8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A255008
  1. Disconnect the 2 engine wire clamps.

  1. Disconnect the engine coolant temperature sensor connector.



    A255009E01
  1. Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.
    Text in Illustration 
    *1
    Ball Joint Lock Nut Wrench
    *2
    Gasket

  1. Remove the gasket from the engine coolant temperature sensor.