Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here


NOTICE:
Perform the Vehicle Identification Number (VIN) registration when replacing the ECM (Click here).

HINT:
When removing only the ECM, it is not necessary to remove the cool air intake duct seal and battery.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE COOL AIR INTAKE DUCT SEAL


    B382622
  1. Remove the 9 clips and cool air intake duct seal.



3. REMOVE BATTERY


    A256224
  1. Disconnect the positive (+) cable from the positive (+) battery terminal.

  1. Loosen the nut and remove the bolt.

  1. Remove the battery and battery tray.



4. REMOVE ECM


    A254787
  1. Disconnect the 2 ECM connectors.

    1. Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

      NOTICE:
      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.



    A254792E01
  1. Remove the nut.

  1. Remove the screw (A).

  1. Loosen the screw (B) and remove the ECM.

  1. Remove the screw (B).



    A254793
  1. Remove the 2 screws and no. 2 ECM bracket.



5. REMOVE NO. 1 ECM BRACKET


    A254783
  1. Remove the nut.

  1. Disconnect the wire harness clamp.



    A254786
  1. Disconnect the wire harness clamp.



    A249913
  1. Remove the nut and no. 1 ECM bracket.