Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)


    A231950E01
  1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
    Text in Illustration 
    *1
    O-ring

  1. Install the camshaft position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. If there is any adhesive remaining on the bolt for the camshaft position sensor, clean and degrease the threads of the bolt.
    2. Make sure that the O-ring is not cracked or does not jump out of position during installation.

  1. Connect the camshaft position sensor connector.



2. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)


    A231950E01
  1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
    Text in Illustration 
    *1
    O-ring

  1. Install the camshaft position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. If there is any adhesive remaining on the bolt for the camshaft position sensor, clean and degrease the threads of the bolt.
    2. Make sure that the O-ring is not cracked or does not jump out of position during installation.

  1. Connect the camshaft position sensor connector.



3. INSPECT FOR OIL LEAK


4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Fit the 3 retainers and install the No. 1 engine cover sub-assembly.