Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A255403
  1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.



2. REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)


    A195076
  1. Disconnect the camshaft position sensor connector.

  1. Remove the bolt and camshaft position sensor.



3. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)


    A254799
  1. Disconnect the camshaft position sensor connector.

  1. Remove the bolt and camshaft position sensor.