Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


    A157503E07
  1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
    Text in Illustration 
    *1
    O-ring

  1. Install the crankshaft position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. If there is any adhesive remaining on the bolt for the crankshaft position sensor, clean and degrease the threads of the bolt.
    2. Make sure that the O-ring is not cracked or does not jump out of position during installation.

  1. Connect the crankshaft position sensor connector.



2. INSPECT FOR OIL LEAK