GENERATOR (for 100 A, 130 A Type) > INSPECTION |
| 1. INSPECT GENERATOR PULLEY WITH CLUTCH |
![]() |
Hold the center of the generator pulley with clutch, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
| *a | Free |
| *b | Lock |
| 2. INSPECT GENERATOR DRIVE END FRAME BEARING |
![]() |
Check that the generator drive end frame bearing is not rough or worn and that it rotates smoothly.
If the generator drive end frame bearing is rough or worn, or does not rotate smoothly, replace the generator drive end frame bearing.
| 3. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using a vernier caliper, measure the length of the exposed brushes.
| *a | Length |
| 4. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.
If the generator rotor bearing is rough or worn, or does not rotate smoothly, replace the generator rotor assembly.
![]() |
Check the generator rotor assembly for an open circuit.
| *a | Slip Ring |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Slip ring - Slip ring | Approx. 20°C (68°F) | 1.8 to 2.2 Ω (for 100 A Type) 1.55 to 1.95 Ω (for 130 A Type) |
![]() |
Check the generator rotor assembly for a short to ground.
| *a | Slip Ring |
| *b | Rotor |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Slip ring - Rotor | Always | 10 MΩ or higher |
Check the slip ring.
Check that the slip rings are not rough or scored.
If the slip rings are rough or scored, replace the generator rotor assembly.
![]() |
Using a vernier caliper, measure the slip ring diameter.
| *a | Diameter |