Home › Power Source / Network · 6AR-FSE BATTERY / CHARGING › GENERATOR

GENERATOR > INSPECTION

for Preparation Click here



1. INSPECT GENERATOR PULLEY WITH CLUTCH


    A208964E03
  1. Hold the center of the generator pulley with clutch, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

    OK:
    The outer ring turns counterclockwise and does not turn clockwise.

    Text in Illustration 
    *a
    Free
    *b
    Lock
    If the result is not as specified, replace the generator pulley with clutch.



2. INSPECT GENERATOR DRIVE END FRAME BEARING


    A192785
  1. Check that the generator drive end frame bearing is not rough or worn and that it rotates smoothly.
    If the generator drive end frame bearing is rough or worn, or does not rotate smoothly, replace the generator drive end frame bearing.



3. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    A128079E12
  1. Using a vernier caliper, measure the length of the exposed brushes.
    Text in Illustration 
    *a
    Length

    Standard Exposed Brush Length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum Exposed Brush Length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the generator brush holder assembly.



4. INSPECT GENERATOR ROTOR ASSEMBLY


    A192784
  1. Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.
    If the generator rotor bearing is rough or worn, or does not rotate smoothly, replace the generator rotor assembly.



    A097476E14
  1. Check the generator rotor assembly for an open circuit.
    Text in Illustration 
    *a
    Slip Ring

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      Approx. 20°C (68°F)
      1.8 to 2.2 Ω

      If the result is not as specified, replace the generator rotor assembly.



    A097477E13
  1. Check the generator rotor assembly for a short to ground.
    Text in Illustration 
    *a
    Slip Ring
    *b
    Rotor

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Rotor
      Always
      10 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.



  1. Check the slip ring.

    1. Check that the slip rings are not rough or scored.
      If the slip rings are rough or scored, replace the generator rotor assembly.



    2. A097470E07
    3. Using a vernier caliper, measure the slip ring diameter.
      Text in Illustration 
      *a
      Diameter

      Standard Diameter:
      14.2 to 14.8 mm (0.559 to 0.583 in.)

      Minimum Diameter:
      14 mm (0.551 in.)

      If the diameter is less than the minimum, replace the generator rotor assembly.