GENERATOR > REASSEMBLY |
| 1. INSTALL GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST and a press, install a new generator drive end frame bearing.
![]() |
Fit the tabs of the retainer plate into the cutouts of the generator drive end frame to install the retainer plate.
| *a | Tab |
| *b | Cutout |
Install the 4 screws.
| 2. INSTALL GENERATOR ROTOR ASSEMBLY |
Place the generator drive end frame on the generator pulley with clutch.
Install the generator rotor assembly to the generator drive end frame.
| 3. INSTALL GENERATOR COIL ASSEMBLY |
![]() |
Install a new bearing cover packing.
| *a | Protrusion |
| *b | Groove |
![]() |
Using a 21 mm deep socket wrench and press, slowly install the generator coil assembly.
| *a | 21 mm Deep Socket Wrench |
Install the 4 bolts.
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
While pushing the 2 brushes into the generator brush holder assembly, insert a 1.0 mm (0.0394 in.) pin into the generator brush holder assembly hole.
| *a | Pin (1.0 mm) |
![]() |
Install the generator brush holder assembly to the generator coil assembly with the 2 screws.
| *a | Pin |
Pull out the pin from the generator brush holder assembly hole.
| 5. INSTALL GENERATOR REAR END COVER |
Install the generator terminal insulator to the generator coil assembly.
Install the generator rear end cover to the generator coil assembly with the 3 bolts.
| 6. INSTALL GENERATOR PULLEY WITH CLUTCH |
Secure the generator assembly in a vise between aluminum plates.
Temporarily install the generator pulley with clutch to the rotor shaft.
![]() |
Install SST (A) and (B) to the generator pulley with clutch as shown in the illustration.
| *a | Rotor Shaft |
![]() |
Tighten the generator pulley with clutch by turning SST (B) as shown in the illustration.
| *a | Torque Wrench Fulcrum Length |
Remove SST (A) and (B) from the generator pulley with clutch.
Check that the generator pulley with clutch rotates smoothly.
Remove the generator assembly from the vise.