Home › Engine / Hybrid System ยท 6AR-FSE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A315230E01
  1. Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.
    Text in Illustration 
    *1
    Engine Under Cover LH
    *a
    Hose

  1. Loosen the radiator drain cock plug.



    A338632E01
  1. Remove the radiator cap sub-assembly. Then drain the engine coolant.
    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  1. Disconnect the hose from the radiator drain cock.



2. REMOVE GENERATOR ASSEMBLY
(Click here)


3. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    A337915
  1. Remove the dust cover from the V-ribbed belt tensioner assembly.



    A337916
  1. Remove the bolt and V-ribbed belt tensioner assembly from the water inlet housing.



4. REMOVE ENGINE WATER PUMP ASSEMBLY


    A348245
  1. Remove the 7 bolts, engine water pump assembly and water pump gasket.