THERMOSTAT > INSTALLATION |
| 1. INSTALL THERMOSTAT |
Install a new gasket to the thermostat.
![]() |
Install the thermostat to the water inlet housing.
| *a | Jiggle Valve |
| *b | 10° |
| 2. INSTALL WATER INLET |
Install the water inlet with the 2 nuts.
| 3. CONNECT NO. 2 RADIATOR HOSE |
Connect the No. 2 radiator hose.
| 4. INSTALL GENERATOR ASSEMBLY |
| 5. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Slowly fill the radiator assembly with engine coolant.
Remove the reserve tank cap.
Slowly pour engine coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 radiator hose and No. 2 radiator hose several times by hand, and then check the level of the engine coolant.
If the engine coolant level is low, add engine coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the engine coolant for several minutes.
Maintain the engine speed at 2500 to 3000 rpm.
Squeeze the No. 1 radiator hose and No. 2 radiator hose several times by hand to bleed air from the cooling system.
Stop the engine, and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 6. INSPECT FOR COOLANT LEAK |
Remove the radiator cap sub-assembly.
![]() |
Fill the radiator assembly with engine coolant, and then install a radiator cap tester.
| *a | Radiator Cap Tester |
Warm up the engine.
Pump the radiator cap tester to 118 kPa (1.2 kgf/cm2, 17 psi), and then check that the pressure does not drop.
Remove the radiator cap tester.
Install the radiator cap sub-assembly.