Home › Engine / Hybrid System ยท 2AR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A315230E01
  1. Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.
    Text in Illustration 
    *1
    Engine Under Cover LH
    *a
    Hose

  1. Loosen the radiator drain cock plug.



    A338632E01
  1. Remove the radiator cap sub-assembly. Then drain the engine coolant.
    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  1. Disconnect the hose from the radiator drain cock.



2. DISCONNECT NO. 2 RADIATOR HOSE


    A255407
  1. Disconnect the No. 2 radiator hose.



3. REMOVE WATER INLET


    A194908
  1. Remove the 2 nuts and water inlet.



4. REMOVE THERMOSTAT
  1. Remove the thermostat.

  1. Remove the gasket from the thermostat.