Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

DTC    B15A0    LAN Master Malfunction

DTC    B15AD    Navigation Processor Malfunction

DTC    B15B0    Display Screen Malfunction

DTC    B15B2    Digital TV Tuner Malfunction

DTC    B15B3    Radio Tuner Malfunction

DTC    B15B5    DVD Changer Malfunction

DTC    B15B7    Bluetooth Module Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC No.
DTC Detection Condition
Trouble Area
B15A0
When either of the following conditions is met:
  1. Bus malfunction
  2. EEPROM error
Navigation receiver assembly
B15AD
When any of the following conditions is met:
  1. Short to ground or +B or open occurs in gyro signal circuit
  2. Gyro sensor malfunction
  3. GPS receiver malfunction
B15B0
Picture circuit (TFT unit) malfunction
B15B2
RF/IF malfunction
B15B3
When any of the following conditions is met:
  1. AM tuner PLL is unlocked
  2. FM tuner PLL is unlocked
  3. Tuner malfunction
B15B5
When any of the following conditions is met:
  1. Mechanism drive signal malfunction
  2. Load/Eject malfunction
  3. Read mechanism malfunction
  4. Mechanical malfunction
B15B7
"Bluetooth" module malfunction

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output.

    OK:
    No DTCs are output.

    Result:
    Result
    Proceed to
    OK
    A
    NG (for TMMK Made)
    B
    NG (for TMC Made)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMMK Made) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMC Made) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)