Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

DTC    B15C0    Short in GPS Antenna

DTC    B15C1    Open in GPS Antenna

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly.

DTC No.
DTC Detection Condition
Trouble Area
B15C0
Navigation antenna malfunction
  1. Navigation antenna assembly*1
  2. Antenna divider*2
  3. Harness or connector*2
  4. Navigation ECU
B15C1
Navigation antenna power source malfunction
  1. *1: w/o Heated Windshield Defroster System
  2. *2: w/ Heated Windshield Defroster System

WIRING DIAGRAM

w/ Heated Windshield Defroster System:

E354020E02


INSPECTION PROCEDURE

NOTICE:
Check that the navigation antenna assembly cable is properly installed and does not have any sharp bends, pinching or loose connections before performing the following inspection procedure (Click here).

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK MODEL
  1. Choose the model to be inspected.

    Result:
    Result
    Proceed to
    w/ Heated Windshield Defroster System
    A
    w/o Heated Windshield Defroster System
    B



B
Go to step 5
A


3.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - ANTENNA DIVIDER)
  1. Disconnect the I219 antenna divider connector.

  1. Disconnect the I221 navigation ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I219-2 (GPSN1) - I221-1 (GPSN2)
    Always
    Below 1 Ω
    I219-2 (GPSN1) or I221-1 (GPSN2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE ANTENNA DIVIDER
  1. Replace the antenna divider with a new or known good one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output.

OK:
No DTCs are output.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END 

5.INSPECT NAVIGATION ANTENNA ASSEMBLY
  1. Remove the navigation antenna assembly (Click here).



    E279082E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 1a
    Always
    50 to 500 Ω

Text in Illustration 
*a
Component without harness connected
(Navigation Antenna Assembly)


NG
REPLACE NAVIGATION ANTENNA ASSEMBLY (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)