Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE DOOR HINGE TORSION BAR (for TMMK Made)

LUGGAGE DOOR HINGE TORSION BAR (for TMMK Made) > INSTALLATION

for Preparation Click here


NOTICE:
After installing the luggage compartment door torsion bars, use your hand to open and close the luggage door. Make sure the luggage door opens and closes smoothly.



1. INSTALL LUGGAGE COMPARTMENT DOOR TORSION BAR SUPPORT


    B380696
  1. Install a new luggage compartment door torsion bar support as shown in the illustration.



2. INSTALL LUGGAGE DOOR HINGE TORSION BAR LH


    B380689
  1. Connect the luggage door hinge torsion bar LH to the left side luggage door hinge as shown in the illustration.



    B380687E01
  1. Using SST, install the luggage door hinge torsion bar LH to the right side of the vehicle body as shown in the illustration.

    SST
    09804-24010  



    B380694
  1. Connect the luggage door hinge torsion bar LH to the luggage compartment door torsion bar support as shown in the illustration.



3. INSTALL LUGGAGE DOOR HINGE TORSION BAR RH


    B380693
  1. Connect the luggage door hinge torsion bar RH to the right side luggage door hinge as shown in the illustration.



    B380691E01
  1. Using SST, install the luggage door hinge torsion bar RH to the left side of the vehicle body as shown in the illustration.

    SST
    09804-24010  



    B380685
  1. Connect the luggage door hinge torsion bar RH to the luggage compartment door torsion bar support as shown in the illustration.



    B380684
  1. Engage the 2 claws as shown in the illustration.



4. INSTALL NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
  1. Engage the clamp to install the No. 3 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when installing the No. 3 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

  1. Connect the connector.