Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE DOOR HINGE TORSION BAR (for TMMK Made)

LUGGAGE DOOR HINGE TORSION BAR (for TMMK Made) > REMOVAL

for Preparation Click here


NOTICE:
When the luggage door hinge torsion bars are removed, their tension will be lost, causing the luggage door to slam close. Therefore, hold the luggage door securely when opening or closing it.



1. REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    B279166
  1. Disconnect the connector.

  1. Disengage the clamp to remove the No. 3 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the No. 3 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.



2. REMOVE LUGGAGE DOOR HINGE TORSION BAR RH


    B380683
  1. Disengage the 2 claws as shown in the illustration.



    B380686
  1. Disconnect the luggage door hinge torsion bar RH from the luggage compartment door torsion bar support as shown in the illustration.



    B380690E01
  1. Using SST, disconnect the luggage door hinge torsion bar RH from the left side of the vehicle body as shown in the illustration.

    SST
    09804-24010  



    B380692
  1. Remove the luggage door hinge torsion bar RH from the right side luggage door hinge as shown in the illustration.



3. REMOVE LUGGAGE DOOR HINGE TORSION BAR LH


    B380695
  1. Disconnect the luggage door hinge torsion bar LH from the luggage compartment door torsion bar support as shown in the illustration.



    B380688E01
  1. Using SST, disconnect the luggage door hinge torsion bar LH from the right side of the vehicle body as shown in the illustration.

    SST
    09804-24010  



    B380712
  1. Remove the luggage door hinge torsion bar LH from the left side luggage door hinge as shown in the illustration.



4. REMOVE LUGGAGE COMPARTMENT DOOR TORSION BAR SUPPORT


    B380697
  1. Remove the luggage compartment door torsion bar support as shown in the illustration.

    NOTICE:
    Make sure to replace the luggage compartment door torsion bar support with a new one.