Home › Vehicle Interior › LIGHTING (INT) › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT TRANSPONDER KEY AMPLIFIER


    E287988E01
  1. Connect a positive (+) lead from the battery to terminal 2 (ILL+) and a negative (-) lead to terminal 4 (ILL-).

  1. Check that the ignition key cylinder light comes on.

    OK:
    Ignition key cylinder light comes on.

    Text in Illustration 
    *a
    Component without harness connected
    (Transponder Key Coil)
    If the result is not as specified, replace the transponder key coil.