Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transmits switch signals via the AVC-LAN communication.
If a short to +B or short to ground occurs in an AVC-LAN communication line, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM


E296389E04


INSPECTION PROCEDURE

HINT:
The radio and display receiver assembly is the master unit.

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
  1. Remove the radio and display receiver assembly (Click here).



    E221758E33
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I155-7 (TX1+) - I155-8 (TX1-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Radio and Display Receiver Assembly)



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
  1. Disconnect the I155 radio and display receiver assembly connector.

  1. Disconnect the I69 stereo component amplifier assembly connector.

  1. Disconnect the X1 rear control switch connector (w/ Rear Control Switch).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I155-7 (TX1+) - I69-7 (TX+)
    Always
    Below 1 Ω
    I155-8 (TX1-) - I69-8 (TX-)
    Always
    Below 1 Ω
    I69-20 (TXD+) - X1-15 (TX+)*
    Always
    Below 1 Ω
    I69-19 (TXD-) - X1-5 (TX-)*
    Always
    Below 1 Ω
    I155-7 (TX1+) - Body ground
    Always
    10 kΩ or higher
    I155-8 (TX1-) - Body ground
    Always
    10 kΩ or higher
    I87-20 (TXD+) - Body ground*
    Always
    10 kΩ or higher
    I87-19 (TXD-) - Body ground*
    Always
    10 kΩ or higher

    1. *: w/ Rear Control Switch



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal.

    HINT:
    1. Check all slave units.
    2. If disconnecting a slave unit causes the master unit to return to normal, the slave unit is defective and should be replaced.

    OK:
    Master unit returns to normal.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

REPLACE MALFUNCTIONING PARTS