CHARGING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK BATTERY CONDITION |
Check the battery for damage and deformation. If severe damage, deformation or leakage is found, replace the battery.
Check the electrolyte quantity of each cell.
![]() |
For maintenance-free batteries:
![]() |
For non-maintenance-free batteries:
Check the voltage.
Turn the engine switch off and turn on the headlights for 20 to 30 seconds. This will remove the surface charge from the battery.
Measure the battery voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Positive (+) terminal - Negative (-) terminal | 20°C (68°F) | 12.5 to 12.9 V |
| 2. INSPECT BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
If the terminals are corroded, clean them.
| 3. INSPECT FUSES |
Measure the resistance of each fuse for the charging system.
| 4. INSPECT V-RIBBED BELT |
![]() |
Check the belt for wear, cracks or other signs of damage.
| *a | INCORRECT |
![]() |
Check that the belt fits properly in the ribbed grooves.
| *a | CORRECT |
| *b | INCORRECT |
| 5. INSPECT GENERATOR WIRING |
Visually check the generator wiring.
Check that the wiring is in good condition.
| 6. CHECK FOR ABNORMAL NOISES |
Check for abnormal noises from the generator.
Check that no abnormal noises are heard from the generator while the engine is running.
| 7. INSPECT CHARGE WARNING LIGHT CIRCUIT |
Turn the engine switch on (IG). Check that the charge warning light comes on.
Start the engine and check that the light goes off.
If the light does not operate as specified, troubleshoot the charge warning light circuit.
| 8. INSPECT CHARGING CIRCUIT WITHOUT LOAD |
![]() |
Connect a voltmeter and an ammeter to the charging circuit as follows.
| *1 | Ammeter |
| *2 | Terminal B |
| *3 | Generator |
| *4 | Voltmeter |
| *5 | Battery |
Disconnect the wire from terminal B of the generator and connect it to the negative (-) lead of the ammeter.
Connect the ammeter positive (+) lead to terminal B of the generator.
Connect the voltmeter positive (+) lead to the positive (+) terminal of the battery.
Ground the voltmeter negative (-) lead.
Check the charging circuit.
Keep the engine speed at 2000 rpm and check the readings on the ammeter and voltmeter.
| 9. INSPECT CHARGING CIRCUIT WITH LOAD |
With the engine running at 2000 rpm, turn the high beam headlights on and turn the heater blower switch to the "HI" position.
Check the reading on the ammeter.