Home › Engine / Hybrid System ยท 2AR-FE › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE RING PIN

NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.

  1. Remove the 12 ring pins.



  1. Using a plastic-faced hammer, install 12 new ring pins.


    A198173E03


    Text in Illustration 
    *a
    Upper Side:
    *b
    Lower Side:
    *c
    Protrusion Height
    -
    -

    Standard Protrusion Height:
    Item
    Specified Condition
    A
    5.0 to 7.0 mm (0.197 to 0.276 in.)
    B
    4.0 to 7.0 mm (0.157 to 0.276 in.)



2. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the 14 straight pins.



  1. Using a plastic-faced hammer, install 14 new straight pins.


    A198175E03


    Text in Illustration 
    *a
    Front Side:
    *b
    Rear Side:
    *c
    LH Side:
    *d
    Lower Side:
    *e
    RH Side:
    *f
    Protrusion Height

    Standard Protrusion Height:
    Item
    Specified Condition
    A
    11.0 to 13.0 mm (0.433 to 0.512 in.)
    B
    5.0 to 7.0 mm (0.197 to 0.276 in.)