CAN COMMUNICATION SYSTEM > Main Body ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Main Body ECU Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the I13 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I13-14 (CANH) - I13-13 (CANL) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Main Body ECU (Multiplex Network Body ECU)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Disconnect the 3B and 3D instrument panel junction block assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-7 (GND1) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3D-31 (BECU) - Body ground | Ignition switch off | 11 to 14 V |
| *a | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (IG1 NO. 2 RELAY AND ACC NO. 1 RELAY) |
Remove the instrument panel junction block assembly (Click here).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.

| *A | for LHD | *B | for RHD |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
| Tester Connection | Condition | Specified Condition |
| 3E-1 - MB-32 (IG) | Always | 10 kΩ or higher |
| 3E-1 - MB-32 (IG) | Battery positive (+) → 3A-27 Battery negative (-) → 3B-7 | Below 1 Ω |
| 3E-1 - MB-29 (ACC) | Always | 10 kΩ or higher |
| 3E-1 - MB-29 (ACC) | Battery positive (+) → 3B-23 Battery negative (-) → 3B-7 | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| 3F-1 - MB-32 (IG) | Always | 10 kΩ or higher |
| 3F-1 - MB-32 (IG) | Battery positive (+) → 3A-27 Battery negative (-) → 3B-7 | Below 1 Ω |
| 3F-1 - MB-29 (ACC) | Always | 10 kΩ or higher |
| 3F-1 - MB-29 (ACC) | Battery positive (+) → 3B-23 Battery negative (-) → 3B-7 | Below 1 Ω |
|
| ||||
| OK | ||
| ||