Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING (for TMC, TMMR Made)

SLIDING ROOF HOUSING (for TMC, TMMR Made) > REASSEMBLY

for Preparation Click here



1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    B279126E01
  1. Engage the 2 guides in the direction indicated by the arrow (1) in the illustration to install the roof wind deflector panel sub-assembly.
    Text in Illustration 
    *1
    Guide
    *2
    Spring

  1. Engage the 2 springs in the direction indicated by the arrow (2) in the illustration.

    NOTICE:
    Make sure that the springs are securely installed.



2. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    B279124
  1. Hold down the roof wind deflector panel sub-assembly.



    B279122E01
  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the other sliding roof drive cable sub-assembly.



3. INSTALL REAR SLIDING ROOF PANEL


    B286384E01
  1. Insert the rear sliding roof panel in the direction indicated by the arrow (1) in the illustration.

  1. Engage the 2 claws in the direction indicated by the arrow (2) in the illustration to install the rear sliding roof panel.



4. ADJUST FULLY CLOSED POSITION


    B286385E01
  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction indicated by the arrows in the illustration and alignment marks.
    Text in Illustration 
    *1
    Alignment Mark

    HINT:
    Tape the screwdriver tip before use.



5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    B286387
  1. Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.



    B279116
  1. Install the sliding roof piece sub-assembly LH with the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    HINT:
    Use the same procedure for the RH side.



6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    B279115
  1. Install the sliding roof drive gear sub-assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B279114E01
  1. Engage the guide and pin.
    Text in Illustration 
    *1
    Guide
    *2
    Pin

  1. Engage the claw and install the map light bracket.