Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING (for TMMK Made)

SLIDING ROOF HOUSING (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
(Click here)


2. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE SLIDING ROOF SIDE GARNISH LH


    B380765
  1. Disengage the 2 claws and remove the sliding roof side garnish LH.



4. REMOVE SLIDING ROOF SIDE GARNISH RH

HINT:
Use the same procedure as for the LH side.



5. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    B380766
  1. Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

    NOTICE:
    To prevent the sliding roof glass and sliding roof drive gear from being displaced, fully close the sliding roof glass (sliding roof drive cable), and then remove the sliding roof glass sub-assembly.



6. REMOVE SLIDING ROOF WEATHERSTRIP
  1. Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.



7. REMOVE REAR NO. 2 SIDE RAIL SPACER LH


    B372640E02
  1. Using a screwdriver, disengage the 2 claws and remove the rear No. 2 side rail spacer LH.
    Text in Illustration 
    *a
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE REAR NO. 2 SIDE RAIL SPACER RH

HINT:
Use the same procedure as for the LH side.



9. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY


    B279111
  1. for Clamp Type:

    1. Disengage the claw and disconnect the sliding roof drain hose.

      HINT:
      Use the same procedure for the other 3 sliding roof drain hoses.



    B279112
  1. for Clip Type:

    1. Expand the clip and disconnect the sliding roof drain hose.

      HINT:
      Use the same procedure for the other 3 sliding roof drain hoses.



  1. Loosen the 8 bolts of the brackets.


    B372641E04


    Text in Illustration 
    *a
    Bracket
    -
    -



  1. Remove the 8 bolts, 8 nuts and sliding roof housing sub-assembly.


    B372642