ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System) > ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND) |
Disconnect the transponder key ECU assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I19-1 (+B) - Body ground | Always | 11 to 14 V |
| I19-2 (IG) - Body ground | Ignition switch off | Below 1 V |
| I19-2 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| I19-5 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||