ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System) > Diagnosis Circuit |

| 1.CHECK HARNESS AND CONNECTOR (DLC3 - TRANSPONDER KEY ECU AND BODY GROUND) |
Disconnect the DLC3 connector.
Disconnect the transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I19-9 (D) - I39-7 (SIL) | Always | Below 1 Ω |
| I39-4 (CG) - Body ground | Always | Below 1 Ω |
| I19-9 (D) - Body ground | Always | 10 kΩ or higher |
| I39-7 (SIL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||