DTC B2780 Push Switch / Key Unlock Warning Switch Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2780 | The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*). |
| Insert the door control transmitter assembly into the ignition key cylinder. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
| B2780 | Key SW |

| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Perform "DTC Output Confirmation Operation" procedure.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B2780 is output | A |
| DTC B2780 is not output | B |
|
| ||||
| A | |
| 3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Pushed (Key set) | Below 1 Ω |
| 1 - 2 | Free (Key removed) | 10 kΩ or higher |
| *a | Component without harness connected (Unlock Warning Switch Assembly) |
| *b | Free |
| *c | Pushed |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - UNLOCK WARNING SWITCH ASSEMBLY - BODY GROUND) |
Disconnect the I19 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I19-3 (KSW) - I33-1 (UN+) | Always | Below 1 Ω |
| I19-3 (KSW) or I33-1 (UN+) - Body ground | Always | 10 kΩ or higher |
| I33-2 (UN-) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||