Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB

HIGH INTENSITY DISCHARGE HEADLIGHT BULB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. PRECAUTION
(Click here)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

CAUTION:
The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.

  1. Disconnect the connector.



    E301889
  1. Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and disconnect it.

    NOTICE:
    1. Do not apply excessive force using a tool.
    2. Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly.



    E301891
  1. Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and remove it.

    NOTICE:
    Do not pull the headlight light control ECU sub-assembly with the socket connected.



4. REMOVE DISCHARGE HEADLIGHT BULB


    E301892E01
  1. Release the set spring as shown in the illustration and remove the discharge headlight bulb.

    NOTICE:
    Do not touch the bulb glass.