FRONT EVAPORATOR TEMPERATURE SENSOR (for TMC, TMMR Made) > REMOVAL |
| 1. REMOVE AIR CONDITIONING UNIT ASSEMBLY |
| 2. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and guide, and remove the No. 1 air duct sub-assembly as shown in the illustration.
| 3. REMOVE NO. 6 HEATER TO REGISTER DUCT ASSEMBLY |
![]() |
Disengage the 2 claws and 2 guides, and remove the No. 6 heater to register duct assembly as shown in the illustration.
| 4. DISCONNECT AIR CONDITIONING HARNESS ASSEMBLY |
![]() |
Remove the heater packing as shown in the illustration.
![]() |
Disconnect the 3 connectors and disengage the 3 guides.
Disconnect the air conditioner harness assembly from the air conditioning unit.
| 5. REMOVE AIR CONDITIONING RADIATOR ASSEMBLY |
![]() |
Remove the 2 screws.
Disengage the 2 claws and remove the air conditioning radiator assembly.
| 6. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts and cooler expansion valve.
| 7. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Remove the 6 screws.
Disengage the 5 claws and remove the plate cover.
![]() |
Disengage the clamp and remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor.
![]() |
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
| 8. REMOVE NO. 1 COOLER THERMISTOR |
![]() |
Remove the No. 1 cooler thermistor.