WATER PUMP > ON-VEHICLE INSPECTION |
| 1. INSPECT FOR COOLANT LEAK |
Visually check the engine water pump assembly.
Check that engine coolant is not dripping from the engine water pump assembly.
Remove the V-ribbed belt (Click here).
Separate the water pump pulley .
Inspect the area around the engine water pump assembly.
![]() |
Press a piece of paper towel against the drain plug and check that the paper towel is not wet and that there are no deposits on the lip of the drain plug.
| *1 | Drain Plug |
Install the water pump pulley .
| 2. INSPECT ENGINE WATER PUMP ASSEMBLY |
![]() |
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the engine water pump assembly.
Install the V-ribbed belt (Click here).