THERMOSTAT > REMOVAL |
| 1. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Loosen the cylinder block drain cock plug (for Bank 1).
Loosen the cylinder block drain cock plug (for Bank 2, w/ Cylinder Block Drain Cock Plug).
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Cylinder Block Drain Cock Plug (for Bank 1) |
| *3 | Cylinder Block Drain Cock Plug (for Bank 2, w/ Cylinder Block Drain Cock Plug) | *4 | Radiator Drain Cock Plug |
| *5 | Air Drain Cock Plug | - | - |
| 2. REMOVE V-RIBBED BELT |
| 3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY |
![]() |
Remove the bolt, No. 2 idler pulley cover plate, No. 2 idler pulley sub-assembly and idler pulley cover plate.
| 4. DISCONNECT NO. 2 RADIATOR HOSE |
![]() |
Disconnect the No. 2 radiator hose.
| 5. REMOVE WATER INLET |
![]() |
Remove the 2 nuts and water inlet.
| 6. REMOVE THERMOSTAT |
Remove the thermostat from the water inlet housing.
Remove the gasket from the thermostat.