Home › Engine / Hybrid System · 2GR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


    A182852
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      11.6 to 12.4 Ω

      If the result is not as specified, replace the injector assembly.



  1. Check the operation.

    CAUTION:
    Perform the inspection in a well-ventilated area.
    Do not perform the inspection near a naked flame.




      A264971E01
    1. Connect SST (fuel tube connector) to SST (hose), then connect them to the fuel pipe (vehicle side).
      Text in Illustration 
      *1
      SST
      (Hose)
      *2
      SST
      (Hose Band)
      *3
      SST
      (Fuel Tube Connector)
      *4
      Fuel Pipe (Vehicle Side)

      SST
      09268-31014   (09268-41500, 09268-41700, 95336-08070)

    2. Install a new O-ring onto the fuel injector assembly.



    3. A264982E01
    4. Connect SST (adapter and hose) to the injector assembly, and hold the injector assembly and union with SST (clamp).
      Text in Illustration 
      *1
      SST
      (Hose)
      *2
      SST
      (Hose Band)
      *3
      SST
      (Adapter)
      *4
      O-ring
      *5
      SST
      (Clamp)
      *6
      Vinyl Tube

      SST
      09268-31014   (09268-41141, 09268-41410, 09268-41700, 95336-08070)



    5. A261671E01
    6. Tie the clamp and adapter together with a tie band as shown in the illustration.
      Text in Illustration 
      *1
      SST
      (Adapter)
      *2
      SST
      (Tie Band)
      *3
      SST
      (Clamp)

      SST
      09268-31014   (09268-41141, 09268-41410, 09268-41800)

    7. Set the injector assembly in a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector assembly to prevent gasoline from spraying.

    8. Operate the fuel pump .



    9. A264973E01
    10. Connect SST (wire) to the injector assembly and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
      Text in Illustration 
      *1
      SST (Wire)
      *a
      Connect

      SST
      09842-30080  

      Standard Injection Volume:
      Tester Connection
      Condition
      Specified Condition
      Positive (+) terminal - Ground terminal
      Per 15 seconds
      84 to 101 cc (5.1 to 6.2 cu. in.)

      Difference between each injector:
      17 cc (1.0 cu. in.) or less

      NOTICE:
      Always switch the voltage on and off on the battery side, not the injector side.

      If the injection volume is not as specified, replace the injector assembly.

  1. Check for leaks.

    1. Disconnect the tester probes of SST (wire) from the battery and check for fuel leaks from the injector.

      Standard fuel drop:
      1 drop or less every 35 minutes