FUEL PUMP (for TMC, TMMR Made) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
![]() |
Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
| a | 100 mm (3.94 in.) or less |
w/ Seat Heater System:
Disconnect the connector.
![]() |
Disengage the 2 clamps.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
| 5. REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
![]() |
Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
| a | 100 mm (3.94 in.) or less |
Disconnect the 2 seat heater connectors.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
| 6. REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) |
![]() |
Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
| 7. REMOVE REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type) |
![]() |
Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
| 8. REMOVE REAR FLOOR SERVICE HOLE COVER |
![]() |
Remove the rear floor service hole cover.
Disconnect the fuel pump connector.
| 9. DISCONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Remove the tube joint clip, and pull out the fuel pump tube.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | Fuel Pump Tube |
| *4 | O-ring |
| *5 | Fuel Suction Plate |
| 10. REMOVE FUEL TANK VENT TUBE SET PLATE |
![]() |
Remove the 8 bolts and set plate.
| 11. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
![]() |
Remove the fuel suction tube with pump and gauge assembly from the fuel tank.
![]() |
Remove the fuel suction tube set gasket from the fuel suction tube assembly.
| *1 | Fuel Suction Tube Set Gasket |