FRONT AXLE HUB > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT AXLE SHAFT NUT |
![]() |
Using SST and a hammer, release the staked part of the front axle shaft nut.
While applying the brakes, remove the front axle shaft nut.
| 3. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt, disengage the clamp and separate the front speed sensor and front flexible hose.
![]() |
Remove the bolt and front speed sensor from the steering knuckle.
| 4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
Remove the 2 bolts and separate the front disc brake caliper assembly.
| 5. REMOVE FRONT DISC |
![]() |
Put matchmarks on the front disc and the front axle hub.
| *a | Matchmark |
Remove the front disc.
| 6. SEPARATE TIE ROD ASSEMBLY |
![]() |
Remove the cotter pin and nut.
![]() |
Install SST to the tie rod assembly LH.
Secure SST using a string.
Using SST, separate the tie rod assembly LH from the steering knuckle.

| *1 | Center Nut | - | - |
| *a | String | *b | Grease Application Area |
![]() | Place the wrench here. | - | - |
| 7. SEPARATE FRONT DRIVE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
| *a | Matchmark |
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
If it is difficult to separate, tap the end of the front drive shaft assembly using a brass bar and a hammer.
| 8. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY |
![]() |
Remove the bolt and 2 nuts, and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.
| 9. REMOVE FRONT AXLE ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts and front axle assembly from the front shock absorber assembly.
| 10. REMOVE FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the front No. 1 wheel bearing dust deflector.
| *1 | Vinyl Tape |
| 11. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the front axle hub hole snap ring.
| 12. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
![]() |
Hold the front axle assembly between aluminium plates in a vise.
Using SST, remove the front axle hub sub-assembly.
![]() |
Using SST and a press, remove the bearing inner race (outside) from the front axle hub sub-assembly.
| 13. REMOVE FRONT DISC BRAKE DUST COVER |
![]() |
Remove the 4 bolts and front disc brake dust cover from the steering knuckle.
| 14. REMOVE FRONT AXLE HUB BEARING |
![]() |
Place the bearing inner race (outside) on the front axle hub bearing.
| *1 | Steel Plate |
| *2 | V-block |
Using SST, a steel plate, V-blocks and a press, remove the front axle hub bearing from the steering knuckle.