REAR AXLE HUB (for TMMK Made) > ON-VEHICLE INSPECTION |
| 1. REMOVE REAR WHEEL |
| 2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the bolt and separate the rear flexible hose from the rear shock absorber assembly.
Remove the 2 bolts, and separate the rear disc brake caliper assembly.
| 3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Remove the parking brake shoe adjusting hole plug.
| 4. REMOVE REAR DISC |
![]() |
Put matchmarks on the rear disc and the rear axle hub.
| *a | Matchmark |
![]() |
Release the parking brake and remove the rear disc.
| 5. INSPECT REAR AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the rear axle hub.
| 6. INSPECT REAR AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.
| 7. INSTALL REAR DISC |
![]() |
Align the matchmarks of the rear disc and rear axle hub, and install the rear disc.
| *a | Matchmark |
| 8. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Install the parking brake shoe adjusting hole plug.
| 9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
Install the rear disc brake caliper assembly with the 2 bolts.
Install the rear flexible hose to the rear shock absorber assembly with the bolt.
| 10. ADJUST PARKING BRAKE |
| 11. INSTALL REAR WHEEL |