REAR AXLE HUB (for TMMK Made) > REMOVAL |
| 1. REMOVE REAR WHEEL |
| 2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the bolt and separate the rear flexible hose from the rear shock absorber assembly.
Remove the 2 bolts, and separate the rear disc brake caliper assembly.
| 3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Remove the parking brake shoe adjusting hole plug.
| 4. REMOVE REAR DISC |
![]() |
Put matchmarks on the rear disc and the rear axle hub.
| *a | Matchmark |
![]() |
Release the parking brake and remove the rear disc.
| 5. DISCONNECT SKID CONTROL SENSOR WIRE |
![]() |
Using a screwdriver, disconnect the connector from the rear speed sensor.
| 6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY |
![]() |
Remove the 4 bolts and the rear axle hub and bearing assembly from the rear axle carrier sub-assembly.