Home › Power Source / Network ยท 6AR-FSE BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > Charging Failure

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION)
  1. Start the engine and visually check that the generator rotor assembly (fan) in the generator assembly is operating.

    OK:
    The generator rotor assembly (fan) is operating.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK


2.CHECK GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION)
  1. Remove the generator assembly (Click here).

  1. Check for forming of particles due to friction (for dry type pulley) or grease leaks (for wet type pulley).

    OK:
    There are no large amounts of particles (for dry type pulley) or grease leaks (for wet type pulley).

  1. Check the generator pulley with clutch for misalignment (interference with the generator assembly).

    OK:
    The generator pulley with clutch is not misaligned (no interference with the generator assembly).



    A288972
  1. Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise.

    OK:
    Noise does not occur when turned in either direction.

  1. Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.

    OK:
    The generator pulley with clutch does not have runout.



    A288971E01
  1. Hold the generator rotor assembly (fan) in the generator assembly with a screwdriver with its tip wrapped with protective tape, and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.
    Text in Illustration 
    *a
    Protective Tape

    OK:
    The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK

REPAIR OR REPLACE GENERATOR ASSEMBLY (Click here)