Home › Power Source / Network ยท 2AR-FE BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > Noise Occurs from Generator while Engine is Running

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK LOOSENESS OF V-RIBBED BELT
  1. Check the tension of the belt by pushing it down with a finger.

    OK:
    The tension of the belt is enough.



NG
REPLACE V-RIBBED BELT TENSIONER ASSEMBLY (Click here)
OK


2.CHECK V-RIBBED BELT FOR WEAR
  1. Check the V-ribbed belt for wear.

    OK:
    The V-ribbed belt is not worn.



NG
REPLACE V-RIBBED BELT (Click here)
OK


3.CHECK GENERATOR PULLEY WITH CLUTCH FOR WEAR
  1. Check the generator pulley with clutch groove for wear or other defects.

    OK:
    The generator pulley with clutch groove is not damaged.

    Result:
    Result
    Proceed to
    OK
    A
    NG (for 100, 130 A)
    B
    NG (for 150 A)
    C



B
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)

C
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
A


4.CHECK FOR NOISE WHILE GENERATOR PULLEY WITH CLUTCH IS OPERATING
  1. Perform a road test and check if noise occurs when decelerating.

    OK:
    Noise does not occur.

    Result:
    Result
    Proceed to
    OK (for 100, 130 A)
    A
    OK (for 150 A)
    B
    NG (for 100, 130 A)
    C
    NG (for 150 A)
    D



B
REPLACE GENERATOR ASSEMBLY (Click here)

C
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)

D
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
A

REPLACE GENERATOR ASSEMBLY (Click here)