Home › Power Source / Network ยท 6AR-FSE BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > Noise Occurs from V-ribbed Belt or Generator Assembly

for Preparation Click here


INSPECTION PROCEDURE

1.CONFIRM PROBLEM SYMPTOM
  1. Confirm the problem symptom.

    Result:
    Symptom
    Proceed to
    Noise occurs from V-ribbed belt assembly.
    A
    Noise occurs from generator assembly.
    B



B
Go to step 6
A


2.CHECK V-RIBBED BELT FOR WEAR
  1. Check the V-ribbed belt for wear or damage.

    OK:
    The V-ribbed belt is not worn or damaged.



NG
REPLACE V-RIBBED BELT (Click here)
OK


3.CHECK GENERATOR PULLEY WITH CLUTCH FOR WEAR
  1. Check the generator pulley with clutch grooves for wear or damage.

    OK:
    The generator pulley with clutch grooves are not worn or damaged.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK


4.CHECK FOR NOISE WHILE CLUTCH PULLEY IS OPERATING
  1. Start the engine and check the generator pulley with clutch for looseness.

    OK:
    The generator pulley with clutch is not loose.



NG
TIGHTEN GENERATOR PULLEY WITH CLUTCH TO SPECIFIED TORQUE
OK


5.INSPECT GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION)
  1. Remove the generator assembly (Click here).

  1. Check for forming of particles due to friction (for dry type pulley) or grease leaks (for wet type pulley).

    OK:
    There are no large amounts of particles (for dry type pulley) or grease leaks (for wet type pulley).

  1. Check the generator pulley with clutch for misalignment (interference with the generator assembly).

    OK:
    The generator pulley with clutch is not misaligned (no interference with the generator assembly).



    A288972
  1. Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise.

    OK:
    Noise does not occur when the generator pulley with clutch is turned in both directions.

  1. Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.

    OK:
    The generator pulley with clutch does not have runout.



    A288971E01
  1. Hold the generator rotor assembly (fan) in the generator assembly with a screwdriver with its tip wrapped with protective tape, and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.
    Text in Illustration 
    *a
    Protective Tape

    OK:
    The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK

INSPECT PULLEY OTHER THAN GENERATOR ASSEMBLY PULLEY 

6.CHECK FOR NOISE WHEN ROTOR IS TURNING FREELY
  1. Perform a road test and check that noise does not occur when decelerating.

    OK:
    Noise does not occur.

  1. Stop the engine and check that generator pulley with clutch noise does not occur as the engine stops.

    OK:
    Noise does not occur.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK


7.CHECK ENGAGEMENT OF GENERATOR PULLEY WITH CLUTCH
  1. Remove the generator assembly (Click here).

  1. Hold the generator rotor assembly (fan) in the generator assembly with a screwdriver with its tip wrapped with protective tape, and check that the generator pulley with clutch locks when turned from counterclockwise (free turning direction) to clockwise (locking direction).

    OK:
    The generator pulley with clutch locks.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK

REPAIR OR REPLACE GENERATOR ASSEMBLY (Click here)